Power 46 Brushless Outrunner Motor

Ideal for 40- to 46-size airplanes weighing 4 to 7 pounds (1.8–3.2 kg), 25- to 40-size 3D airplanes up to 5 pounds (2.2 kg), or models requiring up to 925 watts of power. Features Back to Top Equivalent to 40- to 46-size glow engine for planes weighing 4–7 lb (1.8–3.2 kg) Ideal for 25- to 40-size 3D airplanes up to 5 lb (2.2 kg) Ideal for models requiring up to 925 watts of power High-torque, direct-drive alternative to inrunner brushless motors Includes mount, prop adapters and mounting hardware External rotor design—6mm shaft can easily be reversed for alternative motor installations Slotted 14-pole outrunner design High-quality construction with ball bearings and hardened steel shaft Quiet, lightweight operation Overview Back to Top The Power 46 is designed to deliver clean and quiet power for .40 to 46-size sport and scale airplanes weighing 4 to 7 pounds (1.8–3.2 kg), 25- to 40-size 3D airplanes up to 5 pounds (2.2 kg), or models requiring up to 925 watts of power. It’s an especially good match for Hangar 9 .40-size trainers like the Alpha .40 (HAN2450), Arrow .40 (HAN2625) and warbirds like the T-34 Mentor 40 (HAN2425). Also a great match for sport planes like the Ultra Stick 40 (HAN1675 or HAN1690), Seagull Spacewalker 40 (SEA2050), and smaller sport 3D planes like the Twist 40 (HAN2650). Hardware is included with the purchase of this motor. Examples of Airplane Setups: NOTE: All data measured at full throttle. Actual performance may vary depending on battery and flight conditions. Hangar 9 Ultra Stick 40 ARF (HAN1675 / HAN1690) Option 1: Motor: Power 46 ESC: Castle Creations Phoenix 60 (Standard settings with 12V Soft Li-Po cutoff and no brake) Prop: APC 13x8E Battery: Thunder Power PRO LITE 6000mAh 4S3P (THP60004S3PPL) Flying Weight w/Battery: 5.8 lb Amps Volts Watts Input Watts/Pound RPM 51.5 14.4 745 128 8250 Expect very strong performance with very short takeoff rolls and a great balance of thrust and top speed. Average duration is approximately 12 to 20 minutes depending on throttle management. Option 2: Motor: Power 46 ESC: Castle Creations Phoenix 60 (Standard settings with 12V Soft Li-Po cutoff and no brake) Prop: APC 13x8E Battery: Thunder Power PRO LITE 4200mAh 4S2P (THP42002S2PPL x2 in series) Flying Weight w/Battery: 5.4 lb Amps Volts Watts Input Watts/Pound RPM 47.4 14.1 670 124 8220 Expect strong performance with very short takeoff rolls and a great balance of thrust and top speed. Average duration is approximately 8 to 15 minutes depending on throttle management. Option 3: Motor: Power 46 ESC: Castle Creations Phoenix 60 (Standard settings with 12V Soft cutoff and no brake) Prop: APC 13x8E Battery: Sanyo RC-3000HV 14-Cells (7-Cell packs x2 in series) Flying Weight w/Battery: 6.7 lb Amps Volts Watts Input Watts/Pound RPM 44.0 13.4 590 89 7950 Expect good performance with a good balance of thrust and top speed. Average duration is approximately 5 to 7 minutes depending on throttle management. Tech Notes: Maximum operating temperature: 220 degrees Fahrenheit. Adequate cooling is required for all motor operation at maximum current levels. Maximum burst current duration is 15 seconds. Adequate time between maximum burst intervals is required. You will need... 60A brushless ESC 4S–5S Li-Po or 12- to 16-cell Ni-MH/Ni-Cd 12x8 to 14x10 prop How to Determine a Model's Power Requirement (68 KB) Specifications Back to Top ^ Type: Brushless outrunner Size: Replacement for 40- to 46-size glow engines Bearings or Bushings: One 6 x 15 x 5mm Bearing, and Two 6 x 12 x 4mm Bearing Wire Gauge: 14 Recommended Prop Range: 12x8 to 14x10 Voltage: 14.4 to 19.2 RPM/Volt (Kv): 670 Resistance (Ri): .04 ohms Idle Current (Io): 3.90A @ 10V Shaft Diameter: 6mm (.24 in) Overall Length: 55mm (2.15 in) Weight: 290 g (10.0 oz) Overall Diameter: 50mm (2.00 in) Diameter: 50mm (2 in) Length: 55mm (2.15 in) Continuous Current: 40A Maximum Burst Current: 55A (15 sec) Cells: 12–16 Ni-MH/Ni-Cd or 4–5S Li-Po Speed Control: 60A brushless